Remora Ethernet
========

The latest Remora supported controller boards using Ethernet communications allows LinuxCNC to be run on any supported PC.


LinuxCNC Driver Information
---------------------------

| **LinuxCNC Driver:**      "remora-eth-3.0"
| **LinuxCNC Driver Source:**		https://github.com/scottalford75/Remora/tree/main/LinuxCNC/Components/Remora-eth

Controller Boards
------------

Controller boards for the Remora Ethernet component are more hardware specific than the Remora SPI version. As a result, the firmware is featured accross several branches based on specific hardware. Controller boards include:

**STM32 based controller boards**

* NVEM - an STM32F207 based board with Ethernet PHY chip, originally intended for Mach3.  *[No longer in production, Legacy Support - no new features]*
* EC500 - an STM32F407 based board with Ethernet PHY chip, originally intended for Mach3.  *[No longer in production, Legacy Support - no new features]*
* Expatria Technologies  Flexi-HAL with uFlexiNET Ethernet adapter - an STM32F446 based board with W5500 Ethernet SPI adapter designed for Remora


**iMX RT1052 based controller boards**

* NVEM, EC300 & EC500 - iMXRT1052 based controller boards with Ethernet PHY chip, originally intended for Mach3. [In active development]


**RP2040 based controller boards**

* WIZnet W5500-EVB-Pico - Raspberry Pi RP2040 based development board with on-board W5500 Ethernet SPI adapter
* Expatria Technologies PicoBOB-DLX - Raspberry Pi RP2040 based board with on-board W5500 Ethernet SPI adapter designed for Remora


.. toctree::
   :maxdepth: 2
   
   rt1052
   pico2040
   stm_nvem
   stm_ec500